ElecGear Replacement Joystick and Drift Fix PCB for Controllers, Analog Stick Controller Sensor Thumbsticks for PS5, PS4, Xbox, Xbox Elite, Switch Pro and more by ALPS and FU, Models from EL1 to EL7 - Color EL2 FU 10K for PS4 / PS3
Precio:
Q205.00
Garantía:
Verifica las políticas de Tienda Mundial
Producto de Tienda Mundial
Ocultar detalles
Producto de importación, vendido por Amazon y transportado desde Miami. Cómpralo hoy y recibe en los próximos 6-14 días hábiles.
* Precio y unidades sujetos a revisión de Pacifiko
- Producto - Color EL2 FU 10K for PS4 / PS3
- [EL2 FU 10K for PS4/PS3 Controller] – 4x replacement analog joystick was found in some PS4 DualShock 4 came with PlayStation 4 Pro, and some PS3 controllers also use this version. The thumbstick module was made by Favor Union (FU). The stick controller comes with 10KΩ trimmer potentiometers in orange
- [Compatibility] – The 14 prongs were positioned as the same as ALPS edition. Technically, the whole unit is interchangeable with EL1 ALPS 10K used in PS4 controllers, and other brands like ‘Scuf’ and ‘Razer Raiju Ultimate’ with ALPS joysticks inside. However, the trim pot resistor alone is not interchangeable with ALPS edition
- [Additional Resistor] – Complicated moving mechanism and daily wear and tear finally caused drifting. Even new sensors cannot be 100% balanced. Calibrating in controller settings might not work. We packed 10x correction resistors to solve the potential problem in hardware level. Solder one or two paralleled tiny resistors onto the potentiometer at the opposite direction against drifting. It will help correct 3 to 5 degrees drifting
- [When to replace] – The analog joystick needs to be replaced when your controller has the problem of drifting, creeping, stuttering, a blind spot, a dead spot, a dead zone, no reaction when clicking, or it wouldnt center after years of wear and tear. The OEM genuine repair parts ensure accuracy and prolong lifespan
- [Reminder of DIY] – With as many as 14 prongs, de-soldering and soldering the whole module takes serious skills. We suggest replacing the potentiometers first to solve most of the joystick problems. To desolder the entire joystick module off PCB by a normal soldering iron, please take a look at the desoldering kit at product ID: B0BK7169M8
Información del producto
| PID | NzFiZjI4Zm |
| Número de modelo | B07R7RJ4KY |
| Garantía | 7 días sujeto a las políticas de Tienda Mundial |
Garantía y Soporte
Para más información sobre Garantías en Pacifiko visitar la siguiente pagina: Garantías